![]() ![]() Let's take Firefox and Chrome as examples. ![]() In privacy mode, the browser are not affected by caches and cookies when we are browsing the web, you can try to log in to CPE by privacy window mode. We suggest that you could change browser, clear cache and enable privacy mode. Then we suggest that you can follow the following steps. If you have completed the above steps, you have built the correct topology, and PC also can ping 192.168.0.254, but you still can’t log in the management page of CPE. So when your browser shows you such warning, you may try to disable anti-virus software and check the firewall rules on your PC, and then enter 192.168.0.254 in the browser to login to the web management page again. The browser may show you that your Internet access is blocked. Sometimes, some special firewall or anti-virus software may block our login page. Firewall or anti-virus software on your PC If you don’t know how to ping on PC, please refer to this FAQ.ģ. If you have configured the static IP address for PC, you can test the connection between PC and CPE via Ping command. The default IP address of CPE is 192.168.0.254. You can refer to FAQ710 to set up the PC’s static IP. So the IP address of PC should be configure as 192.168.0.X(X is 2-253). You need configure IP address of PC and CPE in the same subnet.ĭue to the IP address of CPE is 192.168.0.254 in the default factory setting. If the topology is connected correctly, then CPE can be powered up normally.įor detailed installation steps, you can refer to the following page, please click Setup Video to watch the installation steps. ![]() LAN0 port attaches to POE port of POE Adapter The correct topology is shown in the figure: Please confirm the topology among CPE, PC and PoE Adapter. You can refer to these steps to troubleshoot. Special Firewall or anti-virus software blocks Web PagesĪccording to the above reasons, we made some simple steps. IP address of CPE and IP address of PC are not in the same subnetģ. We have listed four common reasons as below:Ģ. There are many different reasons may cause this issue. The "This Article Applies to" section is not updated in a timely manner, to determine if your model supports a specific feature, please refer to the Specifications page of the corresponding product on the TP-Link website.After installing CPE, sometimes you may encounter the problem that can’t log in the web management page to configure CPE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |